-16%

The Cube Orange Standard Set (ADS-B Carrier Board)

The New Orange cube with H7 processor New carrier board with ADSB IN

Standard set which includes

  • Orange Cube and ADSB carrier
  • Power prick mini
  • Wiring pack
  • USB cable
  • fittings (tape screws)

21,000.00

2 in stock (can be backordered)

- +
The Cube Orange Standard Set (ADS-B Carrier Board)

 

What is Cube Orange?

The Cube Orange is a new autopilot from Proficnc / Hex which comes with ADSB IN receiver for detecting manned aircraft flying near UAV / Drones. Cube orange will be the new standard autopilot that will replace The Cube Black as its components are almost reached their life.

The Cube orange come with an H7 processor with extra memory for developers who want to run their own development code on The Cube.

What is ADS-B IN Carrier Board?

ADS-B stands for Automatic dependent surveillance-broadcast (ADS–B) is a surveillance technology in which an aircraft determines its position via satellite navigation. ADS-B is used in manned aircraft. Now onward The Cube Orange will come with a carrier board that will have ADS-B IN receiver built in. This hardware will enable your UAV / Drone to identify any manned aircraft flying nearby or approaching a drone. Autopilot will detect approaching and it will automatically adjust its position so that no collision can take place.

ABS Molding ADS-B Introduction
A 1090MHz ADS-B receiver from uAvionix has been integrated into the new ADS-B carrier board. Autopilot equipped with the new unmanned system can receive information about the location of manned aircraft in the area Information from aircraft including position, altitude, speed, id, etc can be viewed in Mission Planner. Through parameter setting, you can optionally set up your cube orange to allow the vehicle to automatically avoid aircraft Mat is detected in an exclusion zone set by you.

How to use the new ADS-B IN Carrier Board?

The Carrier board has a built-in receiver. With the help of a mission planner if you are using Ardupilot or PX4 or any other firmware which is supported by the mission planner you can configure parameters for enabling or disabling this feature. As of now, this is optional but in future, it might be mandatory to activate ADS-B IN for avoiding UAV /Drone fly near manned aircraft. This restricts UAVs to enter into airspace which is for Commercial or Private airspace.

Specifications of The Cube Orange

Processor :

  • STM32H753VIT6  (32 Bit ARM  Cortex -M7, 400 MHz, 2 MB flash, 1 MB RAM
  • STM32F100 (32 bit ARM  Cortex -M3 24 MHz 8KB SRAM)

Sensors : 

  • Accelerometer  ICM20948 / ICM20649 / IGM20602
  • Gyroscope ICM20948 / ICM20649 / 10420602
  • Compass ICM20948
  • Barometric Pressure Sensor MS5611x2

Operating Conditions and Performance

POWER input voltage / rated input current :  41-57V/25A

POWER rated output/input power: 14W

USB port input voltage / rated input current:   4-57V/250mA

Servo rail input voltage: 33V/5V

Operation Temperature:  -10°C / 55°C

This Product is not waterproof. External waterproof protection is needed if you want to use it where there is the chance of water make come in contact with this product.

 

Weight 355 g
Dimensions 16.5 × 9.5 × 6.5 cm

Reviews

There are no reviews yet.

Be the first to review “The Cube Orange Standard Set (ADS-B Carrier Board)”

Your email address will not be published. Required fields are marked *

Back to top