Your bag is empty
Don't miss out on great deals! Start shopping or Sign in to view products added.
Shop What's New Sign in
- This sensor hub allows to connect two PixHawk Mauch current sensors in parallel in order to add their current capacities.
- The current of both sensors is summarized before reaching the flight controller while the voltage measurement of the LiPo packs are collected from both sensors and passed through the hub to the flight controller.
- The main purpose of this hub is to replace existing protection circuits and to monitor that both paralleled LiPos are supplying the same current to the system.
- Thanks to Mauch Sensor Hub X2, you can spot early when a LiPo starts to fail, way before this situation is irreversible.
- In case of difference in current is of +/- 15%, the alarm output goes ON in order to indicate the fault. The pilote should then land immediately in order to check the batteries.
Mauch 010: PL Sensor Hub X2-V2 with CFK enclosure for UAV/DRONES
₹5,050.00 excl. GST
- Measures current up to 200A and Voltage upto 20S (Max. 85V) with solder bridge open and up to 7S (max. 30V) with solder bridge closed .
- 1x 200A current and voltage measurement sensor, based on Allegro Hall Sensor ACS758-200U, 2x 15cm 8AWG wires (red), Molex CLIK-Mate 1.25mm 4p connector
- 1x CFK enclosure
Mauch 004: PL-200/8 Sensor Board with CFK enclosure
₹4,950.00 excl. GST
Mauch 002: PL-100 Sensor Board with CFK enclosure
₹4,320.00 excl. GST
- 200A - Current measurement sensor board, based on Allegro Hall Sensor ACS-250U.
- The voltage reading of the LiPo is optimized for up to 14S LiPo packs.
- This Sensor board needs a power supply. So please select the matching BEC according to your preference from the BEC section.
- The BEC will also power the flight controller as well as the attached equipment like GPS, telemetry... etc.
- Connected to the sensor are 2x10cm AWG10 wire (red) as a standard.
The board comes with a 10cm connection cable (DF-13-6p <-> DF-13-6p) to the FC. If you need a customized cable in different lengths, then please order it separately.
Mauch MH076: HS-200-HV Sensor Board / 2x 10cm 10AWG
₹4,200.00 excl. GST
50A - Current / Voltage measurement sensor board, based on Allegro Hall Sensor ACS758-050U.MH001: PL-050 Sensor board / 2x 10cm 12AWG / With CFK Enclosue
₹3,999.00 excl. GST
Product description:
.Output 5.30V / 3A -> +/- 0.05V –> Ripple 1mV @ 1.5A output current.. Delivery in PP box: 55 x 55 x 20mm. 1x 021: PL 4-14S HYB-BEC / 1x 5.3V / 3A. 1x 040: PL – Series sensor cable / L=150mmMauch MH021: PL 4-14S HYB-BEC /1×5.3V
₹5,600.00 excl. GST
