Connects a Sensor Board to the SEN. port on a PL BEC, a Sensor Hub X2, a Sensor Hub X8, or a Power-CubeYou can also use this cable to retrofit your own BECMolex CLIK-Mate 1.25mm 4p on both ends / L = 150mm
This sensor hub allows to connect two PixHawk Mauch current sensors in parallel in order to add their current capacities.
The current of both sensors is summarized before reaching the flight controller while the voltage measurement of the LiPo packs are collected from both sensors and passed through the hub to the flight controller.
The main purpose of this hub is to replace existing protection circuits and to monitor that both paralleled LiPos are supplying the same current to the system.
Thanks to Mauch Sensor Hub X2, you can spot early when a LiPo starts to fail, way before this situation is irreversible.
In case of difference in current is of +/- 15%, the alarm output goes ON in order to indicate the fault. The pilote should then land immediately in order to check the batteries.
200A?- Current measurement sensor board, based on Allegro Hall Sensor ACS-250U.
The voltage reading of the LiPo is optimized for up to?14S?LiPo packs.
This Sensor board needs a power supply. So please select the matching BEC according to your preference from the BEC section.
The BEC will also power the flight controller as well as the attached equipment like GPS, telemetry... etc.
Connected to the sensor are 2x10cm?AWG10?wire (red) as a standard.
The board comes with a 10cm connection cable (DF-13-6p <-> DF-13-6p) to the FC. If you need a customized cable in different lengths, then please order it separately.
Module Compatibility- NVIDIA Jetson Xavier
NX, Jetson Orin NX, Jetson Nano
Dimensions- 88 mm x 71 mm
Operating Temperature- -40?C to +85?C
Weight- 40 g