-
Reflex Drive Capacitor CAP BANK ₹2,000.00
-
- Input: 8-60V DC (3-12S LiPo)
- BEC 5V, 5A cont. 6A burst
- BEC 12V, 4A cont. 5A burst
- LDO 3.3V, 500mA cont. PDB 4x70A cont. Total 440A burst
- High Precision Current-sense 440A
- Switchable 12V output
- 1K:20K Battery voltage divider
- 50 55 6mm, 21g
- Mounting holes 30.5mm Dia.3mm
- JST-SH-8pin connector for Flight controllers
Matek PDB FCHUB 12S XCLASS V2
₹2,899.00 excl. GST -
Sale
- 200A – Current measurement sensor board, based on Allegro Hall Sensor ACS-200U.
- This Sensor board needs a power supply. So please select the matching BEC according your preference from the BEC section.
Mauch 076: HS-200-HV ,200A Sensor
Original price was: ₹4,450.00.₹3,533.00Current price is: ₹3,533.00. excl. GSTOriginal price was: ₹4,450.00.₹3,533.00Current price is: ₹3,533.00. excl. GST Add to cart Quick View -
Mauch 090 – 4-14S HYB-BEC / 12V-3A / 2x 20cm 24AWG
₹3,600.00 excl. GST -
Sale
- 200A – Current measurement sensor board, based on Allegro Hall Sensor ACS-200U.
- The BEC will also power the flight controller as well as the attached equipment like GPS, telemetry… etc.
Mauch 075: HS-200-LV , 200A Sensor
Original price was: ₹4,450.00.₹3,533.00Current price is: ₹3,533.00. excl. GSTOriginal price was: ₹4,450.00.₹3,533.00Current price is: ₹3,533.00. excl. GST Add to cart Quick View -
Sale
- This sensor hub allows to connect two PixHawk Mauch current sensors in parallel in order to add their current capacities.
- The current of both sensors is summarized before reaching the flight controller while the voltage measurement of the LiPo packs are collected from both sensors and passed through the hub to the flight controller.
- The main purpose of this hub is to replace existing protection circuits and to monitor that both paralleled LiPos are supplying the same current to the system.
- Thanks to Mauch Sensor Hub X2, you can spot early when a LiPo starts to fail, way before this situation is irreversible.
- In case of difference in current is of +/- 15%, the alarm output goes ON in order to indicate the fault. The pilote should then land immediately in order to check the batteries.
Mauch 010: PL Sensor Hub X2-V2 with CFK enclosure for UAV/DRONES
Original price was: ₹5,050.00.₹3,999.00Current price is: ₹3,999.00. excl. GSTOriginal price was: ₹5,050.00.₹3,999.00Current price is: ₹3,999.00. excl. GST Add to cart Quick View -
Sale
Mauch 003: PL-200 Sensor Board with CFK enclosure
Original price was: ₹4,590.00.₹4,099.00Current price is: ₹4,099.00. excl. GSTOriginal price was: ₹4,590.00.₹4,099.00Current price is: ₹4,099.00. excl. GST Add to cart Quick View -
Sale
Zerodrag Aurora Freestyle LED
Original price was: ₹899.00.₹599.00Current price is: ₹599.00. excl. GST -
- Working Voltage: 6 -28 v
- Output Frequency: 50hz
- Modulation Mode: FMCW
- Centre Frequency: 24.125Ghz
JIYI Terrain following Simulating Radar
₹15,000.00 excl. GST -
Module Compatibility- NVIDIA Jetson Xavier NX, Jetson Orin NX, Jetson Nano Dimensions- 88 mm x 71 mm Operating Temperature- -40°C to +85°C Weight- 40 gVECROS- JETCORE Carrier Board
₹30,000.00 excl. GST -
Max Voltage 12S Capacitance 2800uF Type Electrolytic Current Rating (PCB) 250A Voltage ripple reduction YesReflex Drive Capacitor CAP BANK
₹2,000.00 excl. GST -
Sale
Zerodrag Aurora Race-X LED
Original price was: ₹999.00.₹699.00Current price is: ₹699.00. excl. GST -
4-14S HYBRID BEC with Multiple Outputs Dual 5.35V Single 5.0V Single 12VSVMFG M3004X – 4CH, 4-14S HYBRID BEC
₹13,920.00 excl. GST -
- 4-14S LiPo input with a maximum voltage of 60V
- Dual 5.35V and single 5.0V outputs, each providing 3A
- Advanced LDO power supply with ±0.03V tolerance
SVMFG M3003X 5V – 3CH 4-14S HYBRID BEC
₹10,787.00 excl. GST -
- 4-14S LiPo input with a maximum voltage of 60V
- Dual 5.35V and single 12.0V outputs, each providing 3A
- Advanced LDO power supply with ±0.03V tolerance
SVMFG M3003X 12V 4-14S HYBRID BEC
₹10,787.00 excl. GST
