Compare“Pixhawk Cube Orange+ with ADS-B Carrier Board” has been added to the compare list
AIRBOT MINI CARRIER BOARD AND PDB COMBO 10,678.00 Save:562.00(5%) excl. GST
Description
INTERFACES
PORT
CONNECTOR ON BOARD
CONNECTOR TO PLUG IN
I2C_2 – CAN1 – CAN2
JST GH : BM04B-GHS-TBT
GHR-04V-S
USB – TELEM1 – TELEM2 – GPS2
JST GH : BM06B-GHS-TBT
GHR-06V-S
GPS1
JST GH : BM08B-GHS-TBT
GHR-08V-S
POWER1 – POWER2
Molex CLIKMATE : 502443-0670
502439-0600
*All connectors are the same as Cube Standard carrier board

                                                                            PINOUT

RC SIGNAL AND POWER SELECTION

POWER DISTRIBUTION BOARD (optional)

The Airbot Systems Power Distribution Board Set can be installed directly under Airbot Systems Mini carrier board set. The PDB allows up to 180A through ESC interface and four pairs of low power pads (2 on top/ 2 on bottom). The mounting hole are aligned with Airbot Systems carrier board, so the board can be stacked together while separated by small nylon spacers

ATTENTION ! : The PDB can not be attached to any conductive materials. Beware to distance from any conductive material by
When using nylon spacers or insulations(e.g PlastiDIP), remember to leave enough spacing distance away from conductors.

INSTALLATION DIAGRAM

Features

● Dual power inputs (redundant power with automatic switch to the second power source when first one fails)

● Easy to install on drone (see the mounting pattern above)

● Power distribution & voltage protection (providing current to each connector)

● Motor PWM signal distribution (up to 8 motors – distributed on corners)

● Standard 2.54mm servo PPM/S.BUS/Spectrum RC input (+5v/+3.3v selectable power from carrier board)

● AUX VCC pins are connected together. This allows powering the AUX rail externally

Authorization

UAVGarage is an authorized distributor